Processing

The most important phases of the treatment with respect to orthodox tea production (which can be used for the production of any type of tea desired as opposed to the later explained CTC production) are: withering, rolling, fermenting, drying and sorting into leaf and broken grades, i.e. sizes.

1. Withering

When the fresh leaves reach the factory, they are weighed and the amount is registered. Next, the withering process is commenced where the humidy content of the leaves is reduced by about 30 % in order to make them soft and flexible for the subsequent rolling. The withering takes place in special withering throughs of a length of 25 – 30 m, which are stringed with a wire grid and ventilated with large fans. The leaves are spread out on the grid. The air, which moves through the ventilators, can also be heated if required due to higher humidity content of the leaves. The withering process takes 12 – 18 hours.

2. Rolling

Subsequently, the withering green leaves are rolled in large rolling machines. These generally conist of two large, heavy metal plates, which are rotating against each other and are hereby breaking open the cells, bringing the cell fluid into contact with the oxygen in the air. This introduces the fermentation as well as the development of the essential oils, which then determine the scent and the flvour of the teas. The rolled tea, which now already starts to ferment, is brought into the fermentation room. Some tea factories subsequently use a so-called “rotorvane” machine, a type of shredder, which further processes the leaves. Here, the leaves are moved across a slowly rotating screw conveyor through a cylinder into which oxygen is introduced in order to accelerate the fermentation.

3. Fermentation

The fermentation is an oxidation and tanning process of the cell fluids, which have been released during the rolling. For the fermentation, the leaves are spread out on tables in layers of 10 cm. In modern factories, spraying water from rotating ventilators humidifies the room in which the fermentation takes place. During the fermentation – which takes 2 – 3 hours – the leaves change their colour, which gradually becomes a copper-red. This colour is found again in wet tealeaves of the infusion. The “tea maker” needs to constandly monitor the degree of oxidation, particularly whith respect to the scent of the wet leaves. The quality of the finished tea is very much dependent on the correct fermentation.

4. Drying

The fermentation is finished when the desired grade of fermentation is reached, i. e. as soon as the tea has developed its typical smell and the copper-red colour is dried. For this, so-called tiered dryers are used which are fuelled wiht wood or oil. The tea is moved through the dryer on a conveyor belt. The starting temperature amounts to 90°C and binds the cell fluid firmly to the leaves. Towards the end of the 20-minute long drying process, the temperature decreases to 40°C and the humidity content to approximately 6%. Later, when the tea is infused, the cell fluid, which stuck to the dried leaves, is solved in the hot water and produces the aromatic and invigorating drink.

5. Sorting

The black tea, which is released by the dryer, is the so-called raw tea, which is now sieved via a number of shaking, mechanical sieves wiht varying sieve sizes with which the common leaf grades are separated from each other.

Depending on the sieve sizes, sorting generally yields the following grades:

Leaf Tea – Broken Tea – Fannings – Dust

Generally vaild: the smaller the leaft, the stronger the infusion.

Tea is a natural product, which is made durable by reducing its humidity content. It should be stored in a cool and dry place. The tea retains ist original taste when kept in a tightly closed container, away from strongly smelling foodstuff such as spices.